Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1625)

AMF Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 60.37
Examples To set a packet debug on node 1 with level 1 and no timeout, use the command:
To set a packet debug with level 3 and filter packets received from AMF node 1:
To enable send and receive 500 packets only on vlink1 for packet types 1, 7 and 11, use the
command:
This example applies the debug atmf packet command and uses all of its options:
Example This example applies the debug atmf packet command and combines many of its options:
node_1# debug atmf packet direction tx timeout 0
node_1# debug atmf packet direction tx level 3 filter
node_1
node_1# debug atmf packet num-pkts 500 filter interface
vlink1 pkt-type 1 7 11
node_1# debug atmf packet direction rx level 1 num-pkts
60 filter node x900 interface port1.0.1 pkt-
type 10
node_1# debug atmf packet direction rx level 1 num-pkts
60 filter node x900 interface port1.0.1 pkt-
type 4 7 10