Ip igmp last-member-query-count – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 747

IGMP Snooping Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

Operating System - Version 5.4.4C

31.9

ip igmp last-member-query-count

Use this command to set the last-member query-count value for an interface.

Use the no variant of this command to return to the default on an interface.

Syntax

ip igmp last-member-query-count <2-7>

no ip igmp last-member-query-count

Default

The default last member query count value is 2.

Mode

Interface Configuration for a VLAN interface.

Usage

This command applies to interfaces configured for IGMP, IGMP Snooping, or IGMP Proxy.

This command applies to interfaces configured for IGMP or IGMP Snooping.

Ensure your VLAN is configured first: see

Example

Validation

Commands

show ip igmp interface
show running-config

Related Commands

Parameter

Description

<2-7>

Last member query count value.

awplus#

configure terminal

awplus(config)#

interface vlan2

awplus(config-if)#

ip igmp last-member-query-count 3