Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 853)

IPv4 Hardware Access Control List (ACL) Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 34.7
The source address of the packets. You can specify a single host, a
subnet, or all sources. The following are the valid formats for
specifying the source:
any Matches any source IP address.
host Matches a single source host with the IP
address given by in dotted
decimal notation.
<ip-addr>/
<prefix> An IPv4 address, followed by a forward
slash, then the prefix length. This
matches any source IP address within the
specified subnet.
<ip-addr>
<reverse-mask> Alternatively, you can enter a reverse
mask in dotted decimal format. For
example, entering 192.168.1.1
0.0.0.255
is the same as entering
192.168.1.1/24 .
<destination> The destination address of the packets. You can specify a single
host, a subnet, or all destinations. The following are the valid
formats for specifying the destination:
any Matches any destination IP address.
host Matches a single destination host with
the IP address given by in
dotted decimal notation.
<ip-addr>/
<prefix> An IPv4 address, followed by a forward
slash, then the prefix length. This
matches any destination IP address
within the specified subnet.
<ip-addr>
<reverse-mask> Alternatively, you can enter a reverse
mask in dotted decimal format. For
example, entering 192.168.1.1
0.0.0.255
is the same as entering
192.168.1.1/24 .
icmp-type Matches only a specified type of ICMP messages. This is valid only
when the filtering is set to match ICMP packets.
Table 34-2: Parameters in the access-list (hardware IP numbered) command - ip|
Parameter(cont.) Description(cont.)