Auth-web-server dhcp ipaddress – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1165
Authentication Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
43.39
auth-web-server dhcp ipaddress
Use this command to assign an IP address and enable the DHCP service on the web
authentication server for supplicants (client devices).
Use the no variant of this command to remove an IP address and disable the DHCP service
on the web authentication server for supplicants.
Syntax
auth-web-server dhcp ipaddress <ip-address/prefix-length>
no auth-web-server dhcp ipaddress
Default
No IP address for the web authentication server is set by default.
Mode
Global Configuration
Usage
See the section
“DHCP server for Web-authentication” on page 42.10
Authentication Introduction and Configuration
for further overview information about
the Web-authentication enhancements, allowing Web-authentication to work as
seamlessly as 802.1X authentication.
See the section
“Limitations on Allowed Feature Combinations” on page 42.29
for
information about restrictions regarding combinations of authentication enhancements
working together.
Examples
To assign the IP address 10.0.0.1 to the web authentication server, use the following
commands:
To remove an IP address on the web authentication server, use the following commands:
Validation
Commands
Related Commands
show auth-web-server
auth-web-server dhcp lease
Parameter
Description
<ip-addr/
prefix-length>
The IPv4 address and prefix length assigned for the DHCP
service on the web authentication server for supplicants.
awplus#
configure terminal
awplus(config)#
auth-web-server dhcp ipaddress 10.0.0.1/8
awplus#
configure terminal
awplus(config)#
no auth-web-server dhcp ipaddress