Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2149)

Stacking Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 83.9
show debugging stack
This command shows which debugging modes are currently enabled for stacking.
Syntax show debugging stack
Mode User Exec and Privileged Exec
Example To display the stack debugging mode status, use the command:
Figure 83-2: Example output from the show debugging stack command
Related Commands debug stack
show running-config stack
Use this command to display the running system information specific to the stack.
show running-config stack
Mode Privileged Exec and Global Configuration
Example To display the stacking running configuration information, use the command:
Output Figure 83-3: Example output from the show running-config stack command
Related Commands show running-config
awplus# show debugging stack
Virtual Chassis Stacking debugging status:
VCS link debugging is on
VCS topology debugging is on
VCS trace debugging is on
awplus# show running-config stack
awplus#show running-config stack
stack virtual-mac
stack virtual-chassis-id 1982
stack management vlan 4000
stack management subnet 192.168.254.0
stack enable
stack 2 priority 20