Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 151)

File Management Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 7.5
Command List
autoboot enable
This command enables the device to restore a release file and/or a configuration file from
external media, such as a USB storage device.
When the Autoboot feature is enabled, the device looks for a special file called
autoboot.txt
on the external media. If this file exists, the device will check the key and
values in the file and recover the device with a new release file and/or configuration file
from the external media. An example of a valid autoboot.txt file is shown in
Figure 7-1 below.
Figure 7-1: Example autoboot.txt file
Use the no variant of this command to disable the Autoboot feature.
Syntax autoboot enable
no autoboot enable
Default The Autoboot feature operates the first time the device is powered up in the field, after
which the feature is disabled by default.
Mode Global Configuration
Example To enable the Autoboot feature, use the command:
To disable the Autoboot feature, use the command:
Related Commands create autoboot
show autoboot
show boot
[AlliedWare Plus]
Copy_from_external_media_enabled=yes
Boot_Release=x310-5.4.4C.rel
Boot_Config=network1.cfg
Note This command is not supported in a stacked configuration.
awplus# configure terminal
awplus(config)# autoboot enable
awplus# configure terminal
awplus(config)# no autoboot enable