Introduction – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 2142

Stacking Commands
Software Reference for x310 Series Switches
83.2
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
Introduction
This chapter provides an alphabetical reference for each of the Stacking commands.
Also note the following stacking trigger commands that are documented in the Triggers
chapter:
type stack disabled-master command on page 77.26
type stack master-fail command on page 77.27
type stack member command on page 77.27
type stack link command on page 77.28
In addition to the stacking commands shown in this chapter, stacking content also exists
in the following commands:
reload command and
show cpu command on page 8.26
show cpu history command on page 8.29
show exception log command on page 10.36
show file systems command on page 7.33
show memory command on page 8.35
show memory history command on page 8.38
show process command on page 8.42
show system command on page 8.46
Caution
Stack operation is only supported if stack virtual-mac is enabled.
For more information refer to:
“Enabling the stack virtual-mac” on page 82.11
and