Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2167)

Stacking Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 83.27
stack virtual-chassis-id
This command specifies the stack virtual chassis ID. The ID selected will determine which
virtual MAC address the stack will use. The MAC address assigned to a stack must be
unique within its network.
Syntax stack virtual-chassis-id <id>
Mode Global Configuration
Usage The virtual-chassis-id entered will form the last 12 bits of a pre selected MAC prefix
component; that is, 0000.cd37.0xxx. If you enable the stack virtual MAC address
feature (by using the
stack virtual-mac command) without using the stack virtual-
chassis-id command to select the virtual-chassis-id, then the stack will select a virtual-
chassis-id from a number within the assigned range.
Example To set the stack virtual-chassis-id to 63 use the commands
This will result in a virtual MAC address of: 0000.cd37.003f.
Related Commands show running-config
show stack
detail
stack virtual-mac
Note The command will not take effect until the switch has been rebooted.
Parameter Description
<id> The value of the ID - enter a number in the range 0 to 4095.
awplus# configure terminal
awplus(config)# stack virtual-chassis-id 63