Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 940)

IPv6 Hardware Access Control List (ACL) Commands
Software Reference for x310 Series Switches
36.8 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
send-to-cpu Specifies the packets to send to the CPU.
Specifying this parameter could result in EPSR
healthcheck messages and other control
packets being dropped.
send-to-mirror Specifies the packets to send to mirror port.
copy-to-cpu Specifies the packets to copy to the CPU.
copy-to-mirror Specifies the packets to copy to the mirror port.
ipv6 IPv6 packet, defined by the following
parameters.
icmp ICMP packet, defined by the following
parameters.
<ipv6-source-address/
prefix-length> Specifies a source address and prefix length.
The IPv6 address prefix uses the format X:X::/
prefix-length. The prefix-length is usually set
between 0 and 64.
<ipv6-source-address> Specifies the IPv6 source address.
The IPv6 address uses the format X:X::X:X.
<ipv6-source-wildcard> Specifies source wildcard bits in IPv6 format
X:X::X:X.
Note that binary 1 represents a don’t care
condition, and binary 0 represents a match.
host <ipv6-source-host> Specifies a single source host address.
The IPv6 address uses the format X:X::X:X.
any Specifies any Source host.
<ipv6-destination-
address/prefix-length> Specifies a destination address and prefix
length.
The IPv6 address uses the format X:X::X:X/Prefix-
Length. The prefix-length is usually set between
0 and 64.
<ipv6-destination-
addrress> Specifies a destination address.
The IPv6 address uses the format X:X::X:X.
<ipv6-destination-
wildcard> Specify destination Wildcard bits in IPv6 format
X:X::X:X.
host <ipv6-destination-
host-address> Specify a single destination host address.
The IPv6 address uses the format X:X::X:X.
any Specifies any destination host.
Optional. Specify to filter by ICMP message type
number. Valid values are from 0 to 255.
Parameter(cont.) Description(cont.)