Lldp med-notifications, Lldp med-notifications command on – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1934

LLDP Commands

Software Reference for x310 Series Switches

71.8

AlliedWare Plus

Operating System - Version 5.4.4C

C613-50046-01 REV A

lldp med-notifications

Use this command to enable LLDP to send LLDP-MED Topology Change Detected SNMP
notifications relating to the specified ports. The switch sends an SNMP event notification
when a new LLDP-MED compliant IP Telephony device is connected to or disconnected
from a port on the switch.

Use the no variant of this command to disable the sending of LLDP-MED Topology Change
Detected notifications relating to the specified ports.

Syntax

lldp med-notifications

no lldp med-notifications

Default

The sending of LLDP-MED notifications is disabled by default.

Mode

Interface Configuration

Examples

To enable the sending of LLDP-MED Topology Change Detected notifications relating to
ports 1.0.1 and 1.0.6, use the commands:

To disable the sending of LLDP-MED notifications relating to ports 1.0.1 and 1.0.6, use the
commands:

Related Commands

lldp notification-interval
lldp notifications
snmp-server enable trap
show lldp interface

awplus#

configure terminal

awplus(config)#

interface port1.0.1,port1.0.6

awplus(config-if)#