Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 32)

Getting Started
Software Reference for x310 Series Switches
1.8 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Global
Configuration
mode
To change from Privileged Exec to Global Configuration mode, enter the command:
From Global Configuration mode, you can configure most aspects of the switch.
The default Global Configuration mode prompt is awplus(config)#.
Lower-level
configuration
modes
A number of features are configured by entering a lower-level mode from Global
Configuration mode.
Some protocols have commands in both Global Configuration mode and lower-level
configuration modes. For example, to configure MSTP, you use:
■ Global Configuration mode to select MSTP as the spanning tree mode
■ MST mode to create instances and specify other MSTP settings
■ Interface Configuration mode to associate the instances with the appropriate ports.
Returning to
higher-level
modes
The following figure shows the commands to use to move from a lower-level mode to a
higher-level mode.
Figure 1-8: Returning to higher-level modes
awplus# configure terminal
AlliedWare Plus CLI modes - returning to higher-level modes
User
Exec mode
Privileged
Exec mode
mode
disable
Command used to
return to this
command mode
Command mode
exit
Sub-modes
exit
end
or Ctrl+Z
or Ctrl+C
Global
Configuration