Verifying the amf network – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1565

AMF Introduction and Configuration

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

Operating System - Version 5.4.4C

59.21

Verifying the AMF network

To check that all nodes have joined the AMF network use the

show atmf command on

page 60.38

with the summary parameter. You can run this command from any node in the

AMF network:

The Current AMF Nodes field in the output above shows that all 5 nodes have joined the
AMF network.

Use the

show atmf command on page 60.38

with the nodes parameter, to check

information on individual nodes:

AMF_Master#show atmf summary
ATMF Summary Information:
ATMF Status : Enabled
Network Name : atmf1
Node Name : AMF_Master
Role : Master
Current ATMF Nodes : 5
AMF_Master#

AMF_Master#show atmf nodes

Node Information:

* = Local device

SC = Switch Configuration:

C = Chassis S = Stackable N = Standalone

Node Device ATMF Node

Name Type Master SC Parent Depth

---------------------------------------------------------------------

* AMF_Master AT-SBx81CFC400 Y C none 0

Member1 SwitchBlade x908 N S AMF_Master 1

Member2 SwitchBlade x908 N S AMF_Master 1

Member4 x510-52GTX N S Member2 2

Member3 x510-52GTX N S Member2 2

Current ATMF node count 5

Note

The Parent field refers to the parent domain and not the upstream device. In the
example output above, Member2 is the domain controller for the parent domain
for Member3 and Member4.