Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 915)

IPv4 Software Access Control List (ACL) Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 35.29
See the table “IPv4 Software Access List Commands and Prompts” in this chapter
which shows the prompts at which ACL commands are entered. See the relevant links
shown for the Related Commands.
Examples To define a standard access-list named my-list and deny any packets from any source,
use the commands:
Alternatively, to define a standard access-list named my-list and enter the IPv4
Standard ACL Configuration mode to deny any packets from any source, use the
commands:
Related Commands (access-list standard named filter)
show running-config
show ip access-list
Note Software ACLs will deny access unless explicitly permitted by an ACL action.
awplus# configure terminal
awplus(config)# access-list standard my-list deny any
awplus# configure terminal
awplus(config)# access-list standard my-list
awplus(config-ip-std-acl)# 5 deny any