Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1601)

AMF Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 60.13
atmf enable
This command manually enables (turns on) the AMF feature for the switch being
configured.
The “no” variant of this command disables (turns off ) the AMF feature on the member
node.
Syntax atmf enable
no atmf enable
Default Once AMF is configured, the AMF feature starts automatically when the switch starts up.
Mode Global Configuration
Usage The switch does not auto negotiate AMF domain specific settings such as the Network
Name. You should therefore, configure your switch with any domain specific (non default)
settings before enabling AMF.
Examples To turn on the AMF the feature
To turn off the AMF feature
This command returns the following display:
MyNode# config terminal
MyNode(config)# atmf enable
MyNode(config)# no atmf enable
% Warning: The ATMF network config has been set to enable
% Save the config and restart the system for this change to take
effect.