Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2103)

sFlow Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 81.9
sflow enable
This command enables sFlow® globally on the switch.
The no variant of this command disables sFlow globally on the switch.
Note that enabling sFlow does not automatically set its operational status to active. To
activate sFlow the following conditions need to be met:
■ sFlow is enabled.
■ The sFlow agent address is set.
■ The sFlow collector address is set to a valid (non zero) IPv4 or IPv6 address.
■ Polling or sampling is enabled on the ports to be sampled or polled.
Syntax sflow enable
no sflow enable
Default sFlow is disabled globally on the switch.
Mode Global Configuration
Example To enable sFlow operation, use the command:
Related Commands show running-config sflow
show sflow
awplus# configure terminal
awplus(config)# sflow enable