Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 320)

Scripting Commands
Software Reference for x310 Series Switches
11.4 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
wait
This command pauses execution of the active script for the specified period of time.
Syntax wait <delay>
Default No wait delay is specified by default to pause script execution.
Mode Privileged Exec (when executed from a script not directly from the command line)
Usage Use this command to pause script execution in an .scp (AlliedWare Plus™ script) or an .sh
(ASH script) file executed by the
activate command. The script must contain an enable
(Privileged Exec mode) command since the wait command is only executed in the
Privileged Exec mode.When a script is activated, the privilege level is set to 1 enabling
User Exec commands to run in the script. If you need to run Privileged Exec commands in
your script you need to add an
enable (Privileged Exec mode) command to the start of
your script.
Example See an example .scp script file extract below that will show port counters for interface
port1.0.1
over a 10 second interval:
Related Commands activate
echo
enable (Privileged Exec mode)
Parameter Description
<delay> <1-65335> Specify the time delay in seconds
enable
show interface port1.0.1
wait 10
show interface port1.0.1