Vlan classifier rule proto – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 464
VLAN Commands
Software Reference for x310 Series Switches
17.36
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
vlan classifier rule proto
Use this command to create a protocol type-based VLAN classifier rule, and map it to a
specific VLAN. See the published IANA EtherType IEEE 802 numbers here:
.
The decimal value that you can enter instead of a protocol name is also a hexadecimal
value for the EtherType field. The EtherType field is a two-octet field in an Ethernet frame.
It is used to show which protocol is encapsulated in the payload of the Ethernet frame.
The no variant of this command removes a previously set rule.
Syntax
vlan classifier rule <1-256> proto <protocol>
encap {ethv2|nosnapllc|snapllc} vlan <1-4094>
no vlan classifier rule <1-256>
Parameter
Description
<1-256>
VLAN Classifier identifier
proto
Protocol type
Specify a protocol either by its decimal number (0-65535) or by one
of the following protocol names:
[arp|2054]
Address Resolution
protocol
[atalkaarp|33011]
Appletalk AARP protocol
[atalkddp|32923]
Appletalk DDP protocol
[atmmulti|34892]
MultiProtocol Over ATM
protocol
[atmtransport|34948]
Frame-based ATM
Transport protocol
[dec|24576]
DEC Assigned protocol
[deccustom|24582]
DEC Customer use
protocol
[decdiagnostics|24581]
DEC Systems Comms
Arch protocol
[decdnadumpload|24577]
DEC DNA Dump/Load
protocol
[decdnaremoteconsole|24578]
DEC DNA Remote
Console protocol
[decdnarouting|24579]
DEC DNA Routing
protocol
[declat|24580]
DEC LAT protocol
[decsyscomm|24583]
DEC Systems Comms
Arch protocol
[g8bpqx25|2303]
G8BPQ AX.25 protocol