Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1591)

AMF Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 60.3
atmf backup
This command can only be applied to a master node. It manually schedules an AMF
backup to start at a specified time and to execute a specified number of times per day.
Syntax atmf backup {default|<hh:mm> frequency <1-24>}
no atmf backup enable
Default Backups run daily at 03:00 AM, by default
Mode Global Configuration
Usage Running this command only configures the schedule. To enable the schedule, you should
then apply the command
atmf backup enable .
Running the ”no” variant of this command will disable the schedule.
Example To schedule backup requests to begin at 11 pm and execute daily, use the following
command:
Related Commands atmf backup enable
atmf backup stop
show atmf backup
Parameter Description
default Restore the default backup schedule.
<hh:mm> Sets the time of day to apply the first backup, in hours and
minutes. Note that this parameter uses the 24 hour clock.
backup Enables AMF backup to external media.
frequency <1-24> Sets the number of times per day that backups will be taken.
VCF_1# configure terminal
VCF_1(config)# atmf backup 23:00 frequency 1
Caution File names that comprise identical text, but with differing case, such as
Test.txt and test.txt, will not be recognized as being different on a FAT32
based backup media such as a USB storage device. However, these filenames
will be recognized as being different on your Linux based switch. Therefore,
for good practice, ensure that you apply a consistent case structure for your
back-up file names.