Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 944)

IPv6 Hardware Access Control List (ACL) Commands
Software Reference for x310 Series Switches
36.12 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
(cont.)
97 Ethernet-within-IP Encapsulation / RFC3378
98 Encapsulation Header / RFC1241
108 IP Payload Compression Protocol / RFC2393
112 Virtual Router Redundancy Protocol /
RFC3768
134 RSVP-E2E-IGNORE / RFC3175
135 Mobility Header / RFC3775
136 UDPLite / RFC3828
137 MPLS-in-IP / RFC4023
138 MANET Protocols / RFC-ietf-manet-iana-07.txt
139-252 Unassigned / IANA
253 Use for experimentation and testing /
RFC3692
254 Use for experimentation and testing /
RFC3692
255 Reserved / IANA
<ipv6-source-prefix/
prefix-length> Specify source address and mask.
The IPv6 address uses the format X:X::X:X/Prefix-Length. The prefix-
length is usually set between 0 and 64.
<ipv6-source-address> Specifies the source address.
The IPv6 address uses the format X:X::X:X.
<ipv6-source-wildcard> Specifies the source wildcard bits, in IPv6 format X:X::X:X .
host <ipv6-source-host> Specifies a single source host.
The IPv6 address uses the format X:X::X:X.
any Specifies any source host.
An abbreviation for the IPv6 prefix
::/0
<ipv6-dest-prefix/prefix-
length> Specifies a destination address and mask.
The IPv6 address prefix uses the format X:X::/prefix-length. The prefix-
length is usually set between 0 and 64.
<ipv6-destination-
address> Specify destination address.
The IPv6 address uses the format X:X::X:X.
<ipv6-destination-
wildcard> Specify destination wildcard bits in IPv6 format X:X::X:X
host <ipv6-destination-
host> Specify a single destination host address.
The IPv6 address uses the format X:X::X:X.
any Specifies any destination host. An abbreviation for the IPv6 prefix ::/0
Parameter(cont.) Description(cont.)