Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1018
QoS Commands
Software Reference for x310 Series Switches
39.12
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
Mode
Class Map Configuration
Examples
To remove the eth-format and the protocol from the class-map cmap1, use the
commands:
To set the eth-format to ethii-tagged and the protocol to 0800 (IP) for class-map
cmap1
, use the commands:
ibm-sna
Protocol Number 80D5 (enter the parameter name or its
number).
appletalk-aarp
Protocol Number 80F3 (enter the parameter name or its
number).
snmp
Protocol Number 814Cv.
ethertalk-2
Protocol Number 809B (enter the parameter name or its
number).
ethertalk-2-aarp
Protocol Number 80F3 (enter the parameter name or its
number).
ipx-snap
Protocol Number 8137 (enter the parameter name or its
number).
ipx-802dot3
Protocol Number FFFF (enter the parameter name or its
number).
ip
Protocol Number 0800 (enter the parameter name or its
number).
ipx
Protocol Number 8137 (enter the parameter name or its
number).
ipv6
Protocol Number 86DD (enter the parameter name or
its number).
Parameter(cont.)
Description(cont.)
awplus#
configure terminal
awplus(config)#
class-map cmap1
awplus(config-cmap)#
no match eth-format protocol
awplus#
configure terminal
awplus(config)#
class-map cmap1
awplus(config-cmap)#
match eth-format ethii-tagged protocol
0800
or
awplus(config-cmap)#
match eth-format ethii-tagged protocol ip