Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 434)

VLAN Commands
Software Reference for x310 Series Switches
17.6 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show port-vlan-forwarding-priority
Use this command to display the highest priority protocol that controls port-vlan
forwarding or blocking traffic. This command displays whether EPSR or Loop Protection is
set as the highest priority for determining whether a port forwards a VLAN, as set by the
port-vlan-forwarding-priority command.
For more information about EPSR, see the section “EPSR Introduction and
Configuration” on page 57.1 .
Syntax show port-vlan-forwarding-priority
Mode Privileged Exec
Example To display the highest priority protocol, use the command:
Output Figure 17-1: Example output from the show port-vlan-forwarding-priority command
Related Commands port-vlan-forwarding-priority
awplus# show port-vlan-forwarding-priority
Port-vlan Forwarding Priority: EPSR