Show power-inline interface detail – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 620
Power over Ethernet Commands
Software Reference for x310 Series Switches
23.22
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
show power-inline interface detail
This command displays detailed information for specified Power over Ethernet (PoE)
port(s) on the Power Sourcing Equipment (PSE).
For information on output options, see
“Controlling “show” Command Output” on
Syntax
show power-inline interface [<port-list>] detail
Mode
User Exec and Privileged Exec
Usage
To show detailed PoE information for all ports on the PSE, do not specify any ports.
The power allocated to each port is listed in the Power allocated row, and is limited
by the maximum power per Powered Device (PD) class, or a user configured power limit.
Example
To display detailed PoE port specific information for the port range 2.0.1 to 2.0.2, use
the following command:
Output
Figure 23-5: Example output from the show power-inline interface detail command
Parameter
Description
<port-list>
Enter the PoE port(s) to display the PoE port specific information.
awplus#
show power-inline interface port2.0.1-port2.0.2
detail
awplus#show power-inline interface port1.0.1-1.0.2 detail
Interface port1.0.1
Powered device type: Desk Phone #1
PoE admin enabled
Priority Low
Detection status: Powered
Current power consumption: 4800 mW
Powered device class: 1
Power allocated: 5000 mW (from configuration)
Detection of legacy devices is disabled
Powered pairs: Data
Interface port1.0.2
Powered device type: Access Point #3
PoE admin enabled
Priority High
Detection status: Powered
Current power consumption: 6720 mW
Powered device class: 2
Power allocated: 7000 mW (from powered device class)
Detection of legacy devices is enabled
Powered pairs: Data