Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1507)

EPSR Introduction and Configuration
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 57.25
Step 4: Add a data VLAN to the EPSR Instance called “blue” (on Transit Nodes A to C)
Step 5: Assign a priority to the ring instance (on Transit Nodes A to C)
Step 6: Enable the EPSR Instance called “blue” (on Transit Nodes A to C)
Step 7: Add the physical port 1.0.1 to VLAN 40 (on Transit Nodes A to C)
awplus(config-epsr)#
epsr blue datavlan 40 On the EPSR instance called blue make vlan 40 the
data VLAN.
This step is mandatory on transit nodes that connect to a common segment, and good practice on other
transit nodes.
awplus(config-epsr)#
epsr blue priority 120 Set the ring instance priority to the priority selected
for the ring 120.
awplus(config-epsr)#
epsr blue state enable Enable the EPSR instance named blue.
awplus(config-epsr)#
exit Exit the EPSR Configuration mode.
awplus(config)#
interface port1.0.1,port1.0.2 Specify the physical ring ports (ports1.0.1 and
ports 1.0.2) that you are configuring and enter the
Interface Configuration mode.
awplus(config-if)#
switchport trunk allowed vlan add 40 Enable VLAN 40 on this port.
awplus(config-if)#
exit Exit the Interface mode and enter the Global
Configuration mode.