Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 2003
Triggers Introduction
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
75.3
Step 3:
Set the trigger type
The trigger type determines how the trigger is activated. To set the trigger to activate:
«
when CPU usage reaches a certain level, use the command:
«
when the link status of a particular interface changes, use the command:
«
when the RAM usage reaches a certain level, use the command:
«
periodically after a set number of minutes, use the command:
«
when a ping poll identifies that a target device’s status has changed, use the
command:
«
if your device reboots, use the command:
«
when a stacking link goes up or down, use the command:
«
at a specific time of the day, use the command:
«
when a USB storage device is either inserted or removed, use the command:
Note that a combined limit of 10 triggers of the type periodic and type time can be
configured. If you attempt to add more than 10 triggers the following error message is
displayed:
awplus(config-trigger)#
type cpu <1-100> [up|down|any]
awplus(config-trigger)#
type interface <interface>
[up|down|any]
awplus(config-trigger)#
type memory <1-100> [up|down|any]
awplus(config-trigger)#
awplus(config-trigger)#
type ping-poll <1-100> {up|down}
awplus(config-trigger)#
awplus(config-trigger)#
awplus(config-trigger)#
awplus(config-trigger)#
% Cannot configure more than 10 triggers with the type time or
periodic