Boot config-file – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 152
File Management Commands
Software Reference for x310 Series Switches
7.6
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
boot config-file
Use this command to set the configuration file to use during the next boot cycle.
Use the no variant of this command to remove the configuration file.
Syntax
boot config-file <filepath-filename>
no boot config-file
Mode
Global Configuration
Usage
You can only specify that the configuration file is on a USB storage device if there is a
backup configuration file already specified in Flash. If you attempt to set the configuration
file on a USB storage device and a backup configuration file is not specified in Flash, the
following error message is displayed:
In a VCStack configuration you can only specify that the configuration file is on an SD card
if there is a card inserted in all stack members. If a stack member has a card removed an
error message is displayed. For example, if stack member 2 does not have a card inserted
the following message is displayed:
For an explanation of the configuration fallback order, see
Note
To ensure correct operation of the chassis and in particular of any cards
inserted after issuing this command, the chassis should be rebooted.
Parameter
Description
Filepath and name of a configuration file.
The specified configuration file must exist in the Flash or
USB filesystem.
Valid configuration files must have a .cfg extension.
% Backup configuration files must be stored in the flash
filesystem
% Stack member 2 has no card inserted