Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1506)

EPSR Introduction and Configuration
Software Reference for x310 Series Switches
57.24 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
On Ring 1 - Configure the Transit Nodes A to C
Step 1: Create the control and data VLANs (on Transit Nodes A to C)
Step 2: Add the EPSR control vlan (ctrl-blue) to EPSR ring ports
Step 3: Create the EPSR Instance called “blue”, make VLAN 5 the control VLAN (on Transit
Nodes A to C)
awplus#
configure terminal Enter the Global Configuration mode.
awplus(config)#
vlan database Enter the VLAN Configuration mode.
awplus(config-vlan)#
vlan 5 name ctrl-blue state enable Enable VLAN 5 called ctrl-blue on the Transit Node.
Specifying the enable state allows forwarding of frames
on the VLAN-aware node.
awplus(config-vlan)#
vlan 40 name data-a state enable Enable VLAN 40 called data-a on the Transit Node.
Specifying the enable state allows forwarding of frames
on the VLAN-aware node.
awplus(config-vlan)#
exit Exit the VLAN Configuration mode and enter the Global
Configuration mode.
awplus(config)#
interface port1.0.1,port1.0.2 Specify the two ring ports (port1.0.1 and
port1.0.2
) that you are configuring and enter the
Interface Configuration mode.
awplus(config-if)#
switchport mode trunk Set the switching characteristics of this port to Trunk
mode.
awplus(config-if)#
switchport trunk allowed vlan add 5 Enable VLAN 5 on these ports.
awplus(config-if)#
switchport trunk native vlan none Remove the native VLAN from the ring ports.
awplus(config)#
epsr configuration Enter the EPSR Configuration mode.
awplus(config-epsr)#
epsr blue mode transit controlvlan 5 Create an EPSR instance called blue on vlan 5.
Make vlan 5 the control VLAN.
Make this node a transit node.