Atmf distribute firmware – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1597
AMF Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
60.9
atmf distribute firmware
This command can be used to upgrade software one AMF node at a time. A URL can be
selected from any media location. The latest compatible release for a node will be selected
from this location.
Several checks are performed to ensure the upgrade will succeed. This includes checking
the current node release boots from flash. If there is enough space on flash the software
release is copied to flash on the new location. The new release name is updated using the
command. The old release will become the backup release file
If a release file exists in a remote device (e.g. TFTP, HTTP, etc.), then the URL should specify
the exact release filename without using a wild card character.
Supported units include, x908, x8100, x610, x210, and all stack configurations.
The command will continue to upgrade software until all nodes are upgraded. At the end
of the upgrade cycle the
command should be used on the working-set.
Syntax
atmf distribute firmware <url> .
Mode
Privileged Exec
Examples
To upgrade nodes in a atmf network with a predefined AMF group called sw_team, use
the following commands:
Command Returns
Parameter
Description
<url>
The URL of the file. See
for valid URL
syntax.
SW_Team1#
atmf working-set group sw_team
=============================
SW_Team1, SW_Team2, SW_Team3:
=============================
Working set join