Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1874)

SNMP MIBs
Software Reference for x310 Series Switches
69.62 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
nextBootFirmware { firmware 2 } Information about the software version to be installed
on the device when booting.
nextBootVersion { nextBootFirmware 1 } Provides information on the software version
(major.minor.interim, for example version 5.4.1) that
the device will boot from. A zero will be returned if the
version cannot be determined.
nextBootPath { nextBootFirmware 2 } The full path to the release file that will be used the
next time the device is rebooted. The URL must not
contain whitespace characters.
Only one set operation can be executed at a time
across all SNMP users and an operation may not be
started unless the current value of nextBootSetStatus
is 'idle'.
Immediately upon executing the set action, the
system will attempt to set the new configuration path,
and the process will continue on the device until it has
completed or a failure occurs.
This object can be set with an empty string in order to
clear the current boot firmware. Otherwise, the path
should be of the form ‘flash:/filename.cfg’ or
'card:/filename.cfg'.
In order to set this object, the file must meet the
following conditions:
■
it must exist
■ it must be located in the root of Flash (on the
active master in a stacked environment) or USB
flash drive
■
it must not be the same as the backup release file
■
it must have a .rel suffix
■ it must pass several internal checks to ensure that
it is a genuine release file
■
in a stacked environment, there must be enough
disk space available to store the release file on
each stack member
nextBootSetStatus { nextBootFirmware 3 } Returns the status of any current operation to set the
next boot release file. The following values may be
returned:
■ 1 (idle) - there is no boot release setting operation
in progress
■ 2 (success) - the last boot release setting operation
completed successfully
■ 3 (failure) - the last boot release setting operation
failed
■
5 (syncing) - a boot release setting operation is
currently in progress and the file is being
synchronized across the stack
When a read of this object returns a value of 'success'
or 'failure', it will immediately be reset to 'idle' and a
new operation may be initiated if desired. A detailed
description of the last completed operation may be
determined by reading nextBootLastSetResult.
nextBootLastSetResult { nextBootFirmware 4 } Gives an indication of the result of the last completed
SNMP operation to set the boot release filename.
Table 69-18: Objects defined in AT-SETUP-MIB
Object Identifier Description Object Identifier