Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 688)

IPv6 Commands
Software Reference for x310 Series Switches
27.10 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
ipv6 nd other-config-flag
Use this command to set the other stateful configuration flag (contained within the router
advertisement field) to be used for IPv6 address auto-configuration. This flag is used to
request the router to provide information in addition to providing addresses.
Use no variant of this command to reset the value to the default.
Syntax ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Default Unset
Mode Interface Configuration for a VLAN interface.
Usage Advertisement flags will not be transmitted unless you have applied the no ipv6 nd
suppress-ra command on page 27.17 . This step is included in the example below.
Example To set the IPv6 other-config-flag on the VLAN interface vlan4, use the following
commands:
Related Commands ipv6 nd suppress-ra
ipv6 nd prefix
ipv6 nd managed-config-flag
Note Setting the ipv6 nd managed-config-flag command on page 27.8 implies that
the ipv6 nd other-config-flag will also be set.
awplus# configure terminal
awplus(config)# interface vlan4
awplus(config-if)# ipv6 nd other-config-flag
awplus(config-if)# no ipv6 nd suppress-ra