beautypg.com

Atmf master – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1609

background image

AMF Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

TM

Operating System - Version 5.4.4C

60.21

atmf master

This command configures the switch to be an AMF master node and automatically creates
an AMF master group. The master node is considered to be the core of the AMF network,
and must be present for the AMF to form. The AMF master has its node depth set to 0.
Note that the node depth vertical distance is determined by the number of Up/Down links
that exist between the node and its master.

An AMF master node must be present for an AMF network to form. Up to two AMF master
nodes may exist in a network, and they “must” be connected by an AMF crosslink.

If the crosslink between two AMF masters fails, then one of the masters will become
isolated from the rest of the AMF network

The “no” variant of this command removes the switch as an AMF master node. The node
will retain its node depth of 0 until the network is rebooted.

Syntax

atmf master

no atmf master

Default

The switch is not configured to be an AMF master node.

Mode

Global Configuration

Example

To specify that this node is an AMF master, use the following command:

Related Commands

show atmf
show atmf group

Note

Master nodes are an essential component of an AMF network. In order to run
AMF, an AMF License is required for each master node.

Note

Node depth is the vertical distance (or level) from the master node (whose depth
value is 0).

VCF-1#

configure terminal

VCF-1(config)#

atmf master