Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1384)

Secure Shell (SSH) Commands
Software Reference for x310 Series Switches
54.2 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Introduction
This chapter provides an alphabetical reference for commands used to configure Secure
Shell (SSH). For more information, see
Chapter 52, Secure Shell (SSH) Introduction , and
Chapter 53, Secure Shell (SSH) Configuration .
Command List
banner login (SSH)
This command configures a login banner on the SSH server. This displays a message on
the remote terminal of the SSH client before the login prompt. SSH client version 1 does
not support this banner.
To add a banner, first enter the command banner login, and hit [Enter]. Write your
message. You can use any character and spaces. Use Ctrl+D at the end of your message to
save the text and re-enter the normal command line mode.
The banner message is preserved if the device restarts.
The no variant of this command deletes the login banner from the device.
Syntax banner login
no banner login
Default No banner is defined by default.
Mode Global Configuration
Examples To set a login banner message, use the commands:
Type CNTL/D to finish.
... banner message comes here ...
^D
awplus(config)#
and enter the message. Use Ctrl+D to finish.
To remove the login banner message, use the commands:
Related Commands show banner login
awplus# configure terminal
awplus(config)# banner login
awplus# configure terminal
awplus(config)# no banner login