Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2160)

Stacking Commands
Software Reference for x310 Series Switches
83.20 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
stack management vlan
Use this command to configure the stack management VLAN ID.
Use the no variant of this command to change the stack management VLAN ID back to the
default (VLAN ID 4094).
Syntax stack management vlan <2-4094>
no stack management vlan
Default 4094
Mode Global Configuration
Usage The management VLAN is used for high speed communication between stacked units.
This command enables you to change the ID of this VLAN.
The default stacking management VLAN ID is 4094, which is the last configurable VLAN ID
in the switch.
The stack management VLAN is created and configured automatically so that the stack
VLAN cannot be used in the stack's VLAN configuration commands
(such as awplus(config-vlan)# vlan <Stack management VLAN ID>).
The management VLAN should only be changed if the default stack VLAN ID needs to be
used in the stack's VLAN configuration.
Examples To set the management VLAN to 4000, enter the following commands:
To reset the management VLAN back to the default (4094), enter the following commands:
Related Commands stack management subnet
Parameter Description
<2-4094> Stack management VLAN ID.
Caution When the command is entered, the updated management VLAN
configuration will take effect once the stack is restarted.
If the management VLAN ID is changed by this command, you can use the
no variant of this command to change it back to default value.
awplus# configure terminal
awplus(config)# stack management vlan 4000
awplus# configure terminal
awplus(config)# no stack management vlan