Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1968)

LLDP Commands
Software Reference for x310 Series Switches
71.42 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Related Commands description (interface)
hostname
lldp transmit receive
Power Class The power class of the PD device on the port (class 0, 1, 2,
3 or 4)
Link Aggregation Whether the link is capable of being aggregated and it is
currently in an aggregation.
Aggregated Port-ID Aggregated port identifier.
Maximum Frame Size The maximum frame size capability of the implemented
MAC and PHY.
LLDP-MED Device
Type LLDP-MED device type
LLDP-MED
Capabilities Capabilities LLDP-MED capabilities supported on the
local port.
Network Policy List of network policies configured on the local port.
VLAN ID VLAN identifier for the port for the specified application
type
Tagged Flag Whether the VLAN ID is to be used as tagged or untagged
Layer-2 Priority: Layer 2 User Priority (in the range 0 to 7)
DSCP Value Diffserv codepoint (in the range 0 to 63)
Location
Identification Location configured on the local port.
Extended Power Via
MDI (PoE) PoE-capability and current status of the PoE parameters
for Extended Power-Via-MDI TLV on the local port.
Power Source The power source the switch currently uses; either
primary power or backup power.
Power Priority The power priority configured on the port; either critical,
high or low.
Power Value The total power the switch can source over a maximum
length cable to a PD device on the port. The value shows
the power value in Watts from the PD side.
Inventory
Management Inventory information for the device.
Table 71-4: Parameters in the output of the show lldp local-info command(cont.)
Parameter Description