Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 328)

Interface Commands
Software Reference for x310 Series Switches
12.8 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show interface
Use this command to display interface configuration and status.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show interface [>]
show interface lo
Mode User Exec and Privileged Exec
Usage Note that the output displayed with this command will show MTU (Maximum
Transmission Unit) size for VLAN interfaces, and MRU (Maximum Received Unit) size for
switch ports.
Example To display configuration and status information for interfaces port1.0.1 and
port1.0.4, use the command:
Parameter Description
<interface-list> The interfaces or ports to configure. An interface-list can be:
■
an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
■ a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen;
e.g. vlan2-8, or port1.0.1-1.0.6, or sa1-2, or
po1-2
■ a comma-separated list of the above;
e.g. port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
lo The local loopback interface.
awplus# show interface port1.0.1,port1.0.4