Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2136)

VCStack Introduction
Software Reference for x310 Series Switches
82.22 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Displaying provisioned hardware status
The status, present or provisioned, appears in monitoring commands such as the
show interface brief command. The following sample output from the show interface
brief command shows the provisioning status of two configured stack members.
A more detailed inspection of the provisioned port 2.0.3 is shown below. Note that the
MAC address is 0000.0000.0000, which is the value applied as a placeholder for all
provisioned ports. Also note that although the port is in the link DOWN state its
administrative state of UP PROVISIONED means that it can be further configured. For
example, it can be associated with a VLAN, or added to a link aggregation group etc.
Figure 82-11: Sample display of existing and provisioned show output (x310
-50)
sh running-config
!
switch 1 provision x310
-50
!
interface port1.0.1-1.0.12
switchport
switchport mode access
!
.end
Figure 82-12: Sample show interface brief output showing hardware provisioning
status
awplus#show interface brief
Interface
Status Protocol
port2.0.24 admin up down
port3.0.1 admin up provisioned
port3.0.2 admin up provisioned
Figure 82-13: Sample display showing provisioning status of a specific port
Interface port2.0.3
Scope: both
Link is DOWN, administrative state is UP PROVISIONED
Thrash-limiting
Status Unknown, Action learn-disable, Timeout 1(s)
Hardware is Ethernet, address is 0000.0000.0000
index 6801 metric 1 mtu 1500 mru 1522
SNMP link-status traps: Disabled
input packets 0, bytes 0, dropped 0, multicast packets 0
output packets 0, bytes 0, multicast packets 0 broadcast
pks0