Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1959)

LLDP Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 71.33
location elin-location-id
Use this command to assign an ELIN location to the ports. The ELIN location must already
exist. This replaces any previous assignment of ELIN location for the ports. Up to one
location of each type can be assigned to a port.
Use the no variant of this command to remove a location identifier from the ports.
Syntax location elin-location-id <elin-loc-id>
no location elin-location-id [<elin-loc-id>]
Default By default no ELIN location is assigned to ports.
Mode Interface Configuration
Usage An ELIN location associated with a port can be transmitted in Location Identification TLVs
via the port.
Before using this command, configure the location using the location elin-location
command.
If an ELIN location is deleted using the no variant of one of the location elin-location
command, it is automatically removed from all ports.
Examples To assign ELIN location 1 to port 1.0.1, use the commands:
To remove an ELIN location from port 1.0.1, use the commands:
Related Commands lldp med-tlv-select
location elin-location
show location
Parameter Description
<elin-loc-id> ELIN location identifier, in the range 1 to 4095.
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# location elin-location-id 1
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# no location elin-location-id