Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 573)

Link Aggregation Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 21.7
lacp port-priority
Use this command to set the priority of a switch port. Ports are selected for aggregation
based on their priority, with the higher priority (numerically lower) ports selected first.
Use the no variant of this command to reset the priority of port to the default.
Syntax lacp port-priority <1-65535>
no lacp port-priority
Default The default is 32768.
Mode Interface Configuration
Example
lacp system-priority
Use this command to set the system priority of a local system. This is used in determining
the system responsible for resolving conflicts in the choice of aggregation groups.
Use the no variant of this command to reset the system priority of the local system to the
default.
Syntax lacp system-priority <1-65535>
no lacp system-priority
Default The default is 32768.
Mode Global Configuration
Example
Parameter Description
<1-65535> Specify the LACP port priority.
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# lacp port-priority 34
Parameter Description
<1-65535> LACP system priority. Lower numerical values have higher priorities.
awplus# configure terminal
awplus(config)# lacp system-priority 6700