Power-inline enable, Power-inline, Enable – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 605

Power over Ethernet Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

Operating System - Version 5.4.4C

23.7

power-inline enable

This command enables Power over Ethernet (PoE) to detect a connected Powered Device
(PD) and supply power from the Power Sourcing Equipment (PSE).

The no variant of this command disables PoE functionality on the selected PoE port(s). No
power is supplied to a connected PD after PoE is disabled on the selected PoE port(s).

Syntax

power-inline enable

no power-inline enable

Default

PoE is enabled by default on all ports on the PSE.

Mode

Interface Configuration

Usage

In a stack of x310 series switches this command is supported on all PoE capable ports.

Select a PoE port, a list of PoE ports, or a range of PoE ports from the preceding

interface

(to configure)

command. If you specify a range or list of ports they must all be PoE

capable ports.

No PoE log messages are generated for specified PoE port(s) after PoE is disabled. The
disabled PoE port(s) still provide Ethernet connectivity after PoE is disabled.

Examples

To disable PoE on ports port1.0.1 to port1.0.4, use the following commands:

To enable PoE on ports port1.0.1 to port1.0.4, use the following commands:

Validation

Commands

show power-inline
show power-inline interface
show power-inline interface detail
show running-config power-inline

awplus#

configure terminal

awplus(config)#

interface port1.0.1-port1.0.4

awplus(config-if)#