Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 848)

IPv4 Hardware Access Control List (ACL) Commands
Software Reference for x310 Series Switches
34.2 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Introduction
This chapter provides an alphabetical reference for the IPv4 Hardware Access Control List
(ACL) commands, and contains detailed command information and command examples
about IPv4 hardware ACLs, which are applied directly to interfaces using the
access-
group command.
To apply ACLs to an LACP channel group, apply it to all the individual switch ports in the
channel group. To apply ACLs to a static channel group, apply it to the static channel
group itself. For more information on link aggregation see
Chapter 20, Link Aggregation
Introduction and Configuration , and Chapter 21, Link Aggregation Commands .
Note See Chapter 33, Access Control Lists Introduction for descriptions of ACLs,
and for further information about rules when applying ACLs see the ACL Rules
section.
See ACL Filter Sequence Numbers and ACL Filter Sequence Number
Behavior sections in Chapter 33, Access Control Lists Introduction about
ACL Filters.
Note Text in parenthesis in command names indicates usage not keyword entry. For
example, access-list hardware (named) indicates named IPv4 hardware ACLs
entered as access-list hardware <name> where <name> is a
placeholder not a keyword.
Note Parenthesis surrounding ACL filters indicates the type of ACL filter not the
keyword entry in the CLI, such as (access-list standard numbered filter)
represents command entry in the format shown in the syntax [<sequence-
number>] {deny|permit} {|host <host-address>|
any}
.
Note Software ACLs will deny access unless explicitly permitted by an ACL action.