Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 954)

IPv6 Software Access Control List (ACL) Commands
Software Reference for x310 Series Switches
37.2 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Introduction
This chapter provides an alphabetical reference for the IPv6 Software Access Control List
(ACL) commands, and contains detailed command information and command examples
about IPv6 software ACLs as applied to Routing and Multicasting, which are not applied to
interfaces.
See all relevant Routing commands and configurations in “Layer Three, Switching and
Routing” and all relevant Multicast commands and configurations in “Multicast
Applications” .
To apply ACLs to an LACP channel group, apply it to all the individual switch ports in the
channel group. To apply ACLs to a static channel group, apply it to the static channel
group itself. For more information on link aggregation see
Chapter 20, Link Aggregation
Introduction and Configuration , and Chapter 21, Link Aggregation Commands .
Note that text in parenthesis in command names indicates usage not keyword entry. For
example, ipv6-access-list (named) indicates named IPv6 ACLs entered as ipv6-
access-list
<name> where <name> is a placeholder not a keyword.
Note also that parenthesis surrounding ACL filters indicates the type of ACL filter not the
keyword entry in the CLI. For example, (ipv6 access-list standard IPv6 filter) represents
command entry in the format:
[>] {deny|permit} {<IPv6-source-address/
prefix-length>|any}.
Note See Chapter 33, Access Control Lists Introduction for descriptions of ACLs,
and for further information about rules when applying ACLs see the ACL Rules
section.
See ACL Filter Sequence Numbers and ACL Filter Sequence Number
Behavior sections in Chapter 33, Access Control Lists Introduction about
ACL Filters.
Note Software ACLs will deny access unless explicitly permitted by an ACL action.