Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1621)

AMF Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 60.33
debug atmf
This command enables the AMF debugging facilities, and displays information that is
relevant (only) to the current node. The detail of the debugging displayed depends on the
parameters specified.
If no additional parameters are specified, then the command output will display all AMF
debugging information, including link events, topology discovery messages and all
notable AMF events.
The “no” variant of this command disables either all AMF debugging information, or only
the particular information as selected by the command’s parameters.
Syntax debug atmf [link|crosslink|database|neighbor|error|all]
no debug atmf [link|crosslink|database|neighbor|error|all]
Default All debugging facilities are disabled.
Mode User Exec and Global Configuration
Usage If no additional parameters are specified, then the command output will display all AMF
debugging information, including link events, topology discovery messages and all
notable AMF events.
Examples To debug all AMF debugging, use the command:
To debug all AMF link debugging, use the command:
Parameter Description
debug Enables the AMF debugging facility.
atmf The Allied Telesis Management Framework (AMF).
link Output displays debugging information relating to uplink or
downlink information.
crosslink Output displays all crosslink events.
database Output displays only notable database events.
neighbor Output displays only notable AMF neighbor events.
error Output displays AMF error events.
all Output displays all AMF events.
Note An alias to the no variant of this command - undebug atmf - exists
elsewhere in this chapter.
node_1# debug atmf
node_1# debug atmf link