Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1878

SNMP MIBs
Software Reference for x310 Series Switches
69.66
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
dfltCnfgExists
{ defaultConfig 2 }
This object will return the value TRUE if the currently
defined default configuration file exists, or FALSE if it
does not.
backupConfig { deviceConfiguration
4 }
backupCnfgPath
{ backupConfig 1 }
The full path to the backup configuration file that will
be used the next time the device is rebooted. The URL
must not contain whitespace characters.
Only one set operation can be executed at a time
across all SNMP users and an operation may not be
started unless the current value of
backupCnfgSetStatus is 'idle'. Immediately upon
executing the set action, the system will attempt to
set the new backup configuration path, and the
process will continue on the device until it has
completed or a failure occurs.
This object can be set with an empty string in order to
clear the current boot configuration. Otherwise, the
path should be of the form ‘flash:/myconfig.cfg’ or
'card:/filename.cfg'.
In order to set this object, the file must meet the
following conditions:
■
it must exist
■
it must be located in the root of Flash (on the
active master in a stacked environment) or USB
flash drive
■
it must have a .cfg suffix
■
in a stacked environment, there must be enough
disk space available to store the configuration file
on each stack member
backupCnfgExists
{ backupConfig 2 }
This object will return the value TRUE if the currently
defined backup configuration file exists, or FALSE if it
does not.
backupCnfgSetStatus
{ backupConfig 3 }
Returns the status of any current operation to set the
next backup boot configuration file. The following
values may be returned:
■
1 (idle) - there is no backup boot configuration
setting operation in progress
■
2 (success) - the last backup boot configuration
setting operation completed successfully
■
3 (failure) - the last backup boot configuration
setting operation failed
■
5 (syncing) - a backup boot configuration setting
operation is currently in progress and the file is
being synchronized across the stack
When a read of this object returns a value of 'success'
or 'failure', it will immediately be reset to 'idle' and a
new operation may be initiated if desired. A detailed
description of the last completed operation may be
determined by reading backupCnfgLastSetResult.
backupCnfgLastSetRes
ult
{ backupConfig 4 }
Gives an indication of the result of the last completed
SNMP operation to set the backup boot configuration
filename.
Table 69-18: Objects defined in AT-SETUP-MIB
Object Identifier
Description
Object Identifier