Introduction, Command list, Introduction command list – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 600
Power over Ethernet Commands
Software Reference for x310 Series Switches
23.2
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
Introduction
Power over Ethernet (PoE) is a technology allowing devices such as IP phones to receive
power over existing LAN cabling.
PoE is configured using the commands in this chapter. Note the Power Sourcing
Equipment (PSE) referred to throughout this chapter is an Allied Telesis PoE switch
running the AlliedWare Plus
TM
Operating System, supporting the IEEE 802.3af and IEEE
802.3at Power Ethernet standards. The Powered Device (PD) referred to throughout this
chapter is a PoE or PoE+ powered device, such as an IP phone or a Wireless Access Point
(WAP).
The commands in this chapter are available on the Allied Telesis x310-26FP and x310-50FP
switches. x310-26FP and x310-50FP switches are Layer 2 PoE+ Gigabit Ethernet switches
with SFP+ support.
Command List
This chapter contains an alphabetical list of commands used to configure Power over
Ethernet (PoE). Each command contains a functional description and shows examples of
configuration and output screens for show commands. These commands are only
supported on PoE capable ports. An error message will display on the console if you enter
a PoE command on a port that does not support PoE. The following chapters offer further
information for configuring PoE on Allied Telesis switches.
■
Chapter 22, Power over Ethernet Introduction
for introductory information about
PoE and how to configure PoE on Allied Telesis switches.
■
for information about which PoE MIB objects are supported.
■
for information about SNMP traps.
■
for SNMP command descriptions used when
configuring SNMP traps for PoE.