Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 941)

IPv6 Hardware Access Control List (ACL) Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 36.9
Mode IPv6 Hardware ACL Configuration
Default Any traffic on an interface controlled by a hardware ACL that does not explicate match a
filter is permitted.
Examples To specify a hardware IPv6 access-list named my-acl1 and add an ACL filter entry that
blocks all ICMP6 echo requests, enter the commands:
To specify a hardware IPv6 access-list named my-acl2 and add an ACL filter entry that
blocks all ICMP6 echo requests on the default VLAN (vlan1), enter the following
commands:
To remove an ACL filter entry that blocks all ICMP6 echo requests from he hardware IPv6
access-list named my-acl1, enter the following commands:
Validation
Commands
show ipv6 access-list (IPv6 Hardware ACLs)
Related Commands ipv6 access-list (named)
(ipv6 access-list named protocol filter)
(ipv6 access-list named TCP UDP filter)
ipv6 traffic-filter
show ipv6 access-list (IPv6 Hardware ACLs)
vlan This parameter can be used in either single or
double-tagged VLAN networks. It is the
conventional VLAN tag (VID). In a double-
tagged network it is sometimes referred to as
the STAG.
<1-4094> The VLAN VID.
Parameter(cont.) Description(cont.)
awplus# configure terminal
awplus(config)# ipv6 access-list my-acl1
awplus(config-ipv6-hw-acl)# deny icmp any any icmp-type 128
awplus# configure terminal
awplus(config)# ipv6 access-list my-acl2
awplus(config-ipv6-hw-acl)# deny icmp any any icmp-type 128
vlan 1
awplus# configure terminal
awplus(config)# ipv6 access-list my-acl1
awplus(config-ipv6-hw-acl)# no deny icmp any any icmp-type 128