The sflow mib – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 2094

sFlow Introduction and Configuration
Software Reference for x310 Series Switches
80.14
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
■
Extended Elements Number
■
Extended Elements
Note that in practice the Ethernet header is usually followed by components for the IP, TCP,
and user data.
sFlow Flow Sample
Fields
■
Counter Sample
■
Sample Type (Counter Sample, 0x0002)
■
‘Sample Sequence Number
■
Sample ID (source ID index value)
■
Sample Interval (as set by the
“sflow polling-interval” on page 81.12
■
Counter Type (1=generic, 2=Ethernet)
Generic Interface
Counters
■
ifIndex
■
ifType
■
ifSpeed
■
ifDirection (0=unknown, 1=full-duplex, 2=half-duplex, 3=in, 4=out
■
ifStatus
■
InOctets
■
InUcastpackets
■
InMulticast packets
■
InBroadcast packets
■
InDiscarded packets (= 0)
■
InPackets containing errors
■
InPackets containing unknown protocols (= 0)
■
OutOctets
■
OutUcast packets
■
OutMulticast packets
■
OutBroadcast packets
■
OutDiscarded packets
■
OutPackets containing errors
■
ifPromiscuous Mode
Ethernet Interface
Counters
■
dot3Stats Alignment Errors (= 0)
■
dot3Stats FCS Errors
■
dot3Stats Single Collision Frames (= 0)
■
dot3Stats Multiple Collision Frames
■
dot3Stats SQE Test Errors
■
dot3Stats Deferred Transmissions (= 0)
■
dot3Stats Late Collisions
■
dot3Stats Excessive Collisions
■
dot3Stats Internal Mac Transmit Errors
■
dot3Stats Carrier Sense Errors (= 0)
■
dot3Stats Frame Too Longs
■
dot3Stats Internal Mac Receive Errors
■
dot3Stats Symbol Errors (= 0)
The sFlow MIB
Your switch fully supports inMon’s sFlow MIB. For more information, see
, and the we