Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1202)

Authentication Commands
Software Reference for x310 Series Switches
43.76 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show auth-web interface
This command shows the status for Web based authentication on the specified interface,
which may be a static channel (or static aggregator) or a dynamic (or LACP) channel group
or a switch port.
Use the optional diagnostics parameter to show authentication diagnostics for the
specified interface. Use the optional sessionstatistics parameter to show authentication
session statistics for the specified interface. Use the optional statistics parameter to show
authentication diagnostics for the specified interface. Use the optional supplicant (client
device) parameter to show the supplicant state for the specified interface.
Syntax show auth-web interface <interface-list>
[diagnostics|sessionstatistics|statistics|supplicant [brief]]
Mode Privileged Exec
Example To display the Web based authentication status for port1.0.6, enter the command:
To display the Web based authentication status for port1.0.1, enter the command:
Parameter Description
The interfaces or ports to configure. An interface-list can be:
■ an interface (e.g. vlan2), a switch port (e.g.
port1.0.6
), a static channel group (e.g. sa2) or a
dynamic (LACP) channel group (e.g. po2)
■
a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen;
e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2, or
po1-2
■
a comma-separated list of the above;
e.g. port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
diagnostics Diagnostics.
sessionstatistics Session statistics.
statistics Statistics.
supplicant Supplicant (client device).
brief Brief summary of supplicant state.
awplus# show auth-web interface port1.0.6
awplus# show auth-web interface port1.0.1