Auth-mac reauth-relearning – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1158

Authentication Commands

Software Reference for x310 Series Switches

43.32

AlliedWare Plus

Operating System - Version 5.4.4C

C613-50046-01 REV A

auth-mac reauth-relearning

This command sets the MAC address learning of the supplicant (client device) to re-
learning for re-authentication on the interface specified in the Interface command mode.

Use the no variant of this command to disable the auth-mac re-learning option.

Syntax

auth-mac reauth-relearning

no auth-mac reauth-relearning

Default

Re-learning for port authentication is disabled by default.

Mode

Interface Configuration for a static channel, a dynamic (LACP) channel group, or a switch
port.

Examples

To enable the re-authentication re-learning feature on interface port1.0.2, use the
following commands:

To disable the re-authentication re-learning feature on interface port1.0.2, use the
following commands:

Validation

Commands

show auth-mac
show auth-mac interface
show running-config

awplus#

configure terminal

awplus(config)#

interface port1.0.2

awplus(config-if)#