Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1937)

LLDP Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 71.11
lldp non-strict-med-tlv-order-check
Use this command to enable non-strict order checking for LLDP-MED advertisements it
receives. That is, use this command to enable LLDP to receive and store TLVs from LLDP-
MED advertisements even if they do not use standard TLV order.
Use the no variant of this command to disable non-strict order checking for LLDP-MED
advertisements, that is, to set strict TLV order checking, so that LLDP discards any LLDP-
MED TLVs that occur before the LLDP-MED Capabilities TLV in an advertisement.
Syntax lldp non-strict-med-tlv-order-check
no lldp non-strict-med-tlv-order-check
Default By default TLV non-strict order checking for LLDP-MED advertisements is disabled. That is,
strict order checking is applied to LLDP-MED advertisements, according to ANSI/TIA-1057,
and LLDP-MED TLVs in non-standard order are discarded.
Mode Global Configuration
Usage The ANSI/TIA-1057 specifies standard order for TLVs in LLDP-MED advertisements, and
specifies that if LLDP receives LLDP advertisements with non-standard LLDP-MED TLV
order, the TLVs in non-standard order should be discarded. This implementation of LLDP-
MED follows the standard: it transmits TLVs in the standard order, and by default discards
LLDP-MED TLVs that occur before the LLDP-MED Capabilities TLV in an advertisement.
However, some implementations of LLDP transmit LLDP-MED advertisements with non-
standard TLV order. To receive and store the data from these non-standard
advertisements, enable non-strict order checking for LLDP-MED advertisements using this
command.
Examples To enable strict TLV order checking, use the commands:
To disable strict TLV order checking, use the commands:
Related Commands show running-config lldp
awplus# configure terminal
awplus(config)# lldp tlv-order-check
awplus# configure terminal
awplus(config)# no lldp tlv-order-check