Stack renumber cascade – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 2163
Stacking Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
83.23
stack renumber cascade
This command is used to renumber the members of a stack so that their IDs are ordered
sequentially, relative to the member's physical position within the stack.
Syntax
stack <stack-ID> renumber cascade [<stack-ID>]
Default
If no stack-ID is specified, the member will take the default ID of 1.
Mode
Global Configuration
Usage
This command is used to renumber the members of a stack so that their stack-IDs are
ordered sequentially, based on physical order of the XEM-STK connections. This would
normally be done either when the stack is initially configured or following a major
reconfiguration.
This command is equivalent to pressing and holding the select button on the XEM-STK to
renumber the stack members. The renumber will start on the specified stack member. If
that stack-ID is not used by any of the existing stack member, the command will be
rejected.
The starting stack member will be renumbered with the new stack-ID specified, or the
default of member ID of 1. The stack-ID of the next physically will be the starting members
ID +1, for example member ID 2. This renumbering will continue in cascading order
around the stack members.
The changes will take place immediately and reboot all stack members. For this reason a
confirmation prompt follows this command entry, asking whether you are sure you want
to renumber and reboot the entire stack.
Example
Related Commands
Caution
Changing the stack numbering will upset the existing stack member
configurations such as port settings etc. This command is intended for use
when the stack is either initially commissioned, or has undergone a major
reconfiguration. In this situation you run the stack renumber command
(which will automatically reboot the switch), then configure the stack
members to meet the new requirements.
Parameter
Description
The ID of the stack member to start renumbering from, (from 1 to 4).
renumber
Change the existing stack-ID.
cascade
Renumber the existing stack-ID in cascade order.
The new ID for the first member renumbered, from 1 to 4.
awplus(config)#
stack 1 renumber cascade
Any existing interface configuration may no longer be valid
Are you sure you want to renumber and reboot the entire stack?
(y/n):
y