Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 611)

Power over Ethernet Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 23.13
service power-inline
This command enables Power over Ethernet (PoE) globally on the Power Sourcing
Equipment (PSE) for all PoE ports.
Syntax service power-inline
no service power-inline
Default PoE functionality is enabled by default on the PSE.
Mode Global Configuration
Usage In a stack, issuing this command enables PoE globally for all PoE ports.
In a stack configuration, only stack members containing PoE hardware will have PoE
enabled by default in software.
Examples To disable PoE on the PSE, use the following commands:
To re-enable PoE on the PSE, if PoE has been disabled, use the following commands:
Validation
Commands
show power-inline
show running-config power-inline
awplus# configure terminal
awplus(config)# no service power-inline
awplus# configure terminal
awplus(config)# service power-inline